53
You can enter the gate way IP for dial-up, which is
provided by your ISP.
Select whether to enable Network Address
Translation (NAT) function. If you do not enable NAT,
you must add a route on the uplink equipment,
otherwise Internet access will fail. Normally NAT is
enabled.
You can select RIP1, RIP2-B or RIP2-M.
You can select None, Both, IN Only or OUT Only.
IGMP (Internet Group Multicast Protocol) is a
session-layer protocol used to establish membership
in a multicast group. The ADSL Router supports both
IGMP version 1 (IGMP-v1) and IGMP version 2
(IGMP-v2). Select Disabled to disable it.
You may enable or disable MLD Proxy. MLD proxy is
enabled only for route mode. It works in an IPv6
environment.
You may Enable or Disable the Dual Stack Lite. The
ADSL Router support IPv4/v6 Dual Stack Internet
Protocol.
Select PPPoA/PPPoE in the ISP encapsulation if your ISP requires you to use
a PPPoE connection. This option is typically used for DSL services. Select
Dynamic PPPoE to obtain an IP address automatically for your PPPoE
Comments to this Manuals