Edimax AR-7286WnA User Manual download pdf (Page 50)

The following table describes the parameters of this page:

Field

Description

IP Common Options

Encapsulation

You can choose 1483 Bridged IP LLC, 1483 Bridged IP

VC-Mux, 1483 Routed IP LLC(IPoA) or 1483 Routed

IP VC-Mux.

IP Unnumbered

You can choose Activated or Deactivated.

Default Route

You can enable or disable the default route. If

enabled, the current PVC will be the default gateway

to the Internet from this device.

TCP MTU Option

You can set a TCP MTU value. The range is from 100

to 1500. The default is 1492.

IPv4 Address

NAT

Select whether to enable Network Address

Translation (NAT) function. If you do not enable NAT,

you must add a route on the uplink equipment,

otherwise Internet access will fail. Normally NAT is

enabled.

Dynamic Route

Select this option to specify the Routing Information

protocol (RIP) version. You can select RIP1, RIP2-B or

RIP2-M.

Direction

You can select None, Both, IN Only or OUT Only to

specify the RIP direction. None is for disabling the

RIP function. Both means the ADSL Router will

periodically send routing information and accept

routing information then incorporate into routing

table. IN only means the ADLS router will only

accept but will not send RIP packets. OUT only

means the ADLS router will only send but not accept

RIP packets.

Multicast

IGMP (Internet Group Multicast Protocol) is a

session-layer protocol used to establish membership

in a multicast group. The ADSL Router supports both

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 91 92

No comments

Edimax AR-7286WnA User Manual Page 50