Edimax WP-S1100 User Manual download pdf (Page 86)

4-2 Troubleshooting

Don’t panic if projector server is not function properly! In most cases, you can

solve the problem by yourself and you don’t have to send the projector server

back to dealer of purchase to ask of help. Please refer to this troubleshooting

table to find out possible solution.

Scenario Solution

Can’t connect to

projector server

1. Check the LED lights located at the front of projector

server. If ‘Power’ LED does not light, do the following

check:

z Check the connection of Power adapter, and if the

electrical outlet you used with Power adapter is

functioning properly.

z Press ‘Power’ button to see if ‘Power’ LED lights

now.

2. If ‘Ready’ LED does not light after you switch the

projector server on after more than 2 minutes, ask the

dealer of purchase for help.

3. Check the network connection.

4. Make sure you connected to correct IP address.

5. If you’re using wireless network, make sure you

connected to correct SSID.

6. If you’re using wireless network, check the WEP /

WPA password.

Remote controller

does not work

1. Replace the battery of remote controller with a new

one (CR-2032 lithium battery).

2. Please point the IR transmitter (located at the top of

remote controller) to the front panel of projector server.

3. Make sure the IR receiver of projector server (labeled

1 2 ... 81 82 83 84 85 86 87 88

No comments

Edimax WP-S1100 User Manual Page 86