Edimax BR-6641 Datasheet download pdf (Page 41)

BR-6641 User Manual

Input the IP Address of LAN Port in [Basic Subnet] - [IP Address] and input the

corresponding subnet mask in [Netmask]. Select the corresponding Speed/Duplex in

[Port-Speed].

RIP Configuration

BR-6641 support RIP (Routing Information Protocols) for both version 1 and 2. RIP

v1 is the basic definition while v2 has some functional enhancements. Please refer to

IETF’s official documents for the complete definition of RIP. If your private LAN

subnet supports RIP, you need to also enable BR-6641’s RIP function, by doing as

follows:

Figure 3.12 LAN Private Subnet / RIP Configuration

If the router in LAN enable RIP v1, check the checkbox in front of RIP v1. If the router

in LAN enable RIP v2, check the checkbox in front of RIP v2.

BR-6641 supports the transmission of RIP packets. If the authentication is enabled

on RIP v2, password must be entered in [Authentication Password] field. If there is no

predefined password, just leave the field blank.

Static Routing Subnet

If there is static routing subnet in LAN, you need to use Static Routing Subnet to fulfil

the configuration. Static Routing Subnet means that a router route out a subnet from

LAN, which is not connected to the BR-6641 directly.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

No comments

Edimax BR-6641 Datasheet Page 41