Edimax HP-5001 User Manual

9

10

11 Step 4 When the setup wizard appears, click “Next” to continue. Step 5 Select where you want to install the utility software, and then click

12

13 Step 6 After the installation is complete, click “Close”. Step 7 An icon will appear on your desktop. Click the icon to open the utility softw

14 Chapter 4: Using the Utility Software 4.1 Main Tab The “Main” tab provides a list of powerline adapters connected to the computer. The upper pane

15 4.2 Privacy Tab In the “Privacy” tab, you can create a private network by changing the default network name and configure its security settings. I

16 4.3 Diagnostics Tab The “Diagnostics” tab displays the system information and history of all remote devices. The upper panel displays technical

17 4.4 About Tab The “About” tab contains some basic information about the software. You can also enable or disable the autoscan function under “Pr

18 Chapter 5: Security Button This section demonstrates how to add or remove devices from a HomePlug AVLN with the “Security (Group)” button. The “Po

1 Copyright Copyright  Edimax Technology Co., Ltd. all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, s

19 Step 2 Press the “Security” button on any device in the network for less than 3 seconds. This should be done within 1 minute. Step 3 Wait for th

20 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital d

21

2 Contents Chapter 1: Introduction ...

3 Chapter 1: Introduction 1.1 Product Features  Data rates up to 500Mbps  Transmits network data via existing electrical wires (no external cabl

4 1.4 System Requirements Operating System Utility can support Windows 2000/XP/Vista/7 CPU Intel Pentium III 2.0GHz (or higher) RAM 128MB (at least)

5 Chapter 2: Adapter 2.1 Ethernet Port You can connect the HP-5001 to a router, a computer, or any network device via this Ethernet port. 2.2 B

6 2.3 LEDs Ethernet Port Green On Ethernet connection established Flashing Network activity Off No Ethernet connection Power Green On Powered on Fl

7 Chapter 3: Utility Software Installation Step 1 Before installing the utility software, make sure that no other powerline utility is installed on

8 Note : You will get the following image, if your computer did not install WinPcap4.1.2 before. Please click “Apply” to install WinPcap4.1.2.